VICTRON 230V MULTIPLUS PURE SINE WAVE INVERTER / CHARGER VE BUS • 12V 1200VA INVERTER 50A BATTERY CHARGER WITH 16A AUTOMATIC TRANSFER SWITCH
Reference No. PMP122120000
Victron MultiPlus 500VA-1600VA:
The new style MultiPlus is set to replace the earlier MultiPlus Compact range. It is a powerful true sine wave inverter, a sophisticated battery charger that features adaptive charge technology and a high-speed AC transfer switch in a single compact enclosure.
In the event of a grid failure, or when shore or generator power is disconnected, the inverter within the Multi is automatically activated and takes over the supply to the connected loads. This happens so fast (less than 20 milliseconds) that computers and other electronic equipment will continue to operate without disruption.
Monitor and control your MultiPlus and system or systems' locally (LAN) or remotely via the internet from anywhere in the world, using the free VRM app and free VRM portal website. Access can be from a phone, tablet, laptop or PC for multiple operating systems. There is no end to the level of control, via the required Color Control GX or Venus GX, from adjusting your MultiPlus to setting a Geofence for hire vehicles and more...
Proven reliability- The full bridge plus toroidal transformer topology has proven its reliability over many years. The inverter is short circuit proof and protected against overheating, whether due to overload or high ambient temperature.
PowerControl - Dealing with limited generator, shore side or grid power (800VA/1200VA)- With the Multi Control Panel a maximum generator or shore current can be set. The MultiPlus will then take account of other AC loads and use whatever is extra for charging, thus preventing the generator or shore supply from being overloaded.
PowerAssist - Boosting the capacity of shore or generator power (800VA/1200VA)- Where peak power is so often required only for a limited period, the MultiPlus will make sure that insufficient shore or generator power is immediately compensated for by power from the battery. When the load reduces, the spare power is used to recharge the battery.
High start-up power- Needed to start high inrush loads such as power converters for LED lamps, halogen lamps or electric tools.
Search Mode- When Search Mode is ‘on’, the power consumption of the inverter in no-load operation is decreased by approx. 70%. In this mode the Multi, when operating in inverter mode, is switched off in case of no load or very low load, and switches on every two seconds for a short period. If the output current exceeds a set level, the inverter will continue to operate. If not, the inverter will shut down again.
Programmable relay- By default, the programmable relay is set as an alarm relay, i.e. the relay will de-energise in the event of an alarm or a pre-alarm (inverter almost too hot, ripple on the input almost too high, battery voltage almost too low).
Remote on / off / charger on- Three pole connector
MultiPlus 12/500/20 MultiPlus 24/500/10 MultiPlus 48/500/6
MultiPlus 12/800/35 MultiPlus 24/800/16 MultiPlus 48/800/9
MultiPlus 12/1200/50 MultiPlus 24/1200/25 MultiPlus 48/1200/13
PowerControl / PowerAssist
Three Phase and parallel operation
Input voltage range
9,5–17V 19 –33V 38–66V
Output voltage: 230VAC±2% Frequency: 50Hz ± 0,1%(1)
Cont. output power at 25°C (3)
Cont. output power at 25°C
Cont. output power at 40°C
Cont. output power at 65°C
90 / 91 / 92%
92 / 93 / 94%
93 / 94/95%
6 / 6 / 7W
7 / 7 / 8W
10 / 9 / 10W
Zero-load power in search mode
2 / 2 / 3W
2 / 2 / 3W
3 / 3 /3W
Input voltage range:187-265VAC Input frequency: 45 – 65Hz
Charge voltage 'absorption'
14,4 / 28,8 / 57,6V
Charge voltage 'float'
13,8 / 27,6 / 55,2V
13,2 / 26,4 /52,8V
Charge current house battery (4)
20 / 10 / 6A
35 / 16 / 9A
50 / 25 / 13A
Charge current starter battery
1A (12V and 24V models only)
Battery temperature sensor
Programmable relay (5)
a – g
Operating temp. range: -40 to +65°C (fan assisted cooling)
Humidity (non-condensing): max 95%
Material & Colour: Steel/ABS (blue RAL 5012) Protection category: IP 21
16 / 10 / 10 mm²
25 / 16 / 10 mm²
35 / 25 / 10 mm²
Dimensions (h x w x d)
311 x 182 x 100 mm
360 x 240 x 100 mm
406 x 250 x 100 mm
EN-IEC 60335-1, EN-IEC 60335-2-29, EN 62109-1
Emission / Immunity
EN 55014-1, EN 55014-2, EN-IEC 61000-3-2, EN-IEC 61000-3-3
IEC 61000-6-1, IEC 61000-6-2, IEC 61000-6-3
f. 230VAC on inverteroutput
g. Input voltage ripple toohigh
3) Non-linear load, crest factor3:1
4) At 25°Cambient
general alarm, DC under voltage or generator start/stop signal function AC rating: 230V/4A
DC rating: 4A up to 35VDC, 1A up to 60VDC